PUMPING SYSTEMS CONTROLS & AUTOMATION
Core supports pump station and lift station control panels, duty/standby and lead/lag alternation, level control using floats, ultrasonic or radar instruments, and pressure transducers. Scope can include VFD pump control, soft starters, constant-pressure booster systems, pump protection for dry-run, seal failure, thermal and phase-loss conditions, flow, pressure and energy monitoring, PLC/SCADA integration, radio or cellular telemetry, alarm dial-out, remote monitoring into Core OneView, generator and emergency-power interfaces, legacy pump-panel modernization, commissioning, operator training, and service. Applications include water and wastewater lift stations, reservoirs, booster stations, mine dewatering, oil and gas transfer or injection pumps, chemical dosing and process pumps, energy plant cooling water, commercial HVAC hydronic and domestic-water booster pumps, and fire-pump status monitoring. Core coordinates with the pump supplier and describes controls, drives, panels, monitoring, and integration scope without implying pump supply.
Core Automation Solutions is a Canadian engineering-led systems integrator. The work connects engineering, automation, controls, systems integration, project delivery, commissioning, service, modernization, and optimization. Core works with owners, operators, engineering firms, EPC/EPCM organizations, contractors, and facility teams when equipment, process, mechanical, electrical, network, data, and operational requirements need to work together. Scope is defined from the actual systems, interfaces, documentation, responsibilities, and testing requirements. Delivery can include control narratives, sequences, point schedules, I/O documentation, drawings, programming, integration, factory and site testing, commissioning support, operator handover, troubleshooting, service, and phased modernization. Core uses evidence-based language: identify the system, measure the conditions, optimize the control strategy, and verify the result. No project, client, certification, safety-system, hazardous-location, uptime, savings, or interoperability claim is implied unless it is confirmed for the specific work. Engineering work can begin with site information, existing drawings, control narratives, points, sequences, equipment schedules, network diagrams, operating concerns, and the responsibilities of each project participant. Automation work can include PLC logic, SCADA screens, HMI workflows, DDC and BAS/BMS sequences, alarms, trends, schedules, data acquisition, and remote visibility. Integration work can connect mechanical, electrical, process, controls, automation, networking, IoT, data, and operations layers after the interfaces are reviewed. Project delivery can include procurement coordination, panel and field interfaces, programming, testing records, commissioning preparation, functional testing, issue tracking, documentation, training, and handover. Service can include troubleshooting, preventive maintenance, corrective work, legacy support, tuning, controller replacement, network upgrades, sensor review, and software support. Modernization can be phased so an existing system is understood before components are replaced. Energy management can identify, measure, optimize, and verify operating changes using meters, trends, schedules, alarms, dashboards, and documented evidence. The appropriate technical scope depends on the facility, process, equipment, access, documentation, schedule, and delivery responsibilities agreed for the work. Core’s public capabilities include engineering and design, automation and controls, industrial automation, building automation, systems integration, digital engineering, project delivery, commissioning, service, modernization, energy management, control panels, and pumping systems. Each page is an entry point for a technical conversation.
Contact Core at info@coreautomationsolutions.com or 1-833-372-6718.